The opposite sides need to be exactly the same length.The two things that are essential for getting square corners are: If you're using a table saw or miter saw and none of the dimensions are critical, then IMO the easiest way to make a mitered frame is to measure from the outside and then use a stop block. Whether to measure from the inside, the outside, or along the rabbet depends on your setup and which measurement is most important to you. There are often several good ways to tackle a woodworking task, and miter joints are certainly in that category. What is the proper way to measure for a miter joint? Make a 2"x2" square spacer to help set up for the shorter sides after you cut the long sides. Be sure to make your frame slightly larger than the glass (if using glass) and the photo or mat that you'll be inserting into it.Ĭommon picture frame sizes are 4圆, 5x7, 8x10.notice a pattern? That's right, the short sides are 2" shorter than the long sides. Don't measure from the outside corner of a miter joint or the inside corner, but rather from what will become the outer edge of the rabbet. Presumably you have a rabbet cut into the back so you can insert the glass (if using glass), photo, and backing. Once you build the sled, you'll be able to cut square miters every time.īut what about the actual lengths of the pieces? Use stop blocks clamped to the fences of your miter sled to cut multiple pieces to exactly the same length. One great solution for getting perfect miter joints is to use a miter sled.
Often in woodworking the best practice is to cut slightly over the final size, then sneak up on the final dimension.
0 kommentar(er)
